HP 5000 Router Series Manual de instalación descargar pdf (Pagina 23)

Connecting the Router to the Ethernet 21

Figure 12 Installing a SIC or MIM

Connecting the Router

to the Ethernet

The Router 5000 Family routers provide a fixed 100BASE-TX fast Ethernet port

that uses category-5 twisted pair cable.

Note the following before you connect:

■ The fixed Ethernet cables are supplied with the router.

■ Use shielded cables to ensure electromagnetic compatibility.

■ Identify the mark on the module so you can plug the cable in correctly.

■ When connecting the Ethernet cable to a LAN Switch, plug the cable into the

10/100BASE-T interface marked with MDIX.

To connect the Ethernet cable:

1 Turn off power to the router.

2 Select the Ethernet cable.

While connecting the router with a PC or a router, use the crossover network

cable.

When connecting the router to a hub or a LAN switch, use the straight-through

network cable.

3 Connect one end of the Ethernet cable to the appropriate Ethernet port on the

router.

4 Connect the other end of the Ethernet cable to the Ethernet port of the network

device.

5 Verify the connection by checking that the 100M ETH LED on the top of the router

is on.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 61 62

Sin comentarios

HP 5000 Router Series Manual de instalación Pagina 23