Hp StorageWorks DAT 72x10 Tape Autoloader Manual de usuario descargar pdf (Pagina 27)

Figure 12 Attaching the power cord

CAUTION:

To disconnect all power from the autoloader, remov e the po wer cord from the outlet. The

powe r butt on only puts the power on stand-by.

7. Turn on the autoloader using the power button. Check the LCD screen to make sure the autoloader

receiving power. If it is not, check the power connections and your power source. During the

Power-On Self Test (POST), all four LEDs are illuminated brieﬂy, followed by a ﬂashing Ready LED.

When the

initialization sequence is complete, the Home screen will be displayed.

8. Plug in the host ser ver or workstation and all attached devices.

9. Turn on any other devices you turned off earlier.

10. Turn on the ser ver.

Verifying the connection

• Depending on the server conﬁguration, you may need to change the SCSI IDs of the autoloader,

“Changing thedriveSCSIID”onpage39.

• Make sure that the correct drivers are installed, and that the backup software is compatible

with the autoloader, see “Drivers and Backup Software” on page 15. Software compatibility

information is available at w

ww.hp.com/go/connect. Backup software packages may require

additional software or licensing to communicate with the autoloader robotics.

• Ensure the autoloader is properly terminated. If the autoloader is the only SCSI device, other

than the

SCSI host adapter on the selected SCSI bus, it must be terminated. Likewise, if the

autoloader is physically the last SCSI device on the SCSI bus, it must be terminated. Only the

devices physically located at the beginning and end of the SCSI bus should be terminated.

• Verify the connection bet ween the autoloader and the host by:

• Installing the HP Library & Tape Tools diagnostic utility available at w

ww.hp.com/supp ort/

TapeToo ls. Install this utility onto the host server. This utility veriﬁes that the autoloader is

connected and communicating with the host server. It also veriﬁes that the autoloader is

functioning and provides diagnostic information.

•Conﬁrming the host server’s operating system recognize d the autoloader in Microsoft® In

Windows® Server 2003 or in Windows 2000® by going to: Settings > Co n trol Panel >

System > Hardware > Device Manager > Ta pe Drive and Settings > Control Panel > System >

Hardware > Device M anager > Media Changer.

For more information on verifying the connection of SCSI devices, consult the o perating system

documentation.

DAT 72x10 1U Tape Autoloader

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 61 62

Sin comentarios

Hp StorageWorks DAT 72x10 Tape Autoloader Manual de usuario Pagina 27