HP rp5800 Manual de usuario descargar pdf (Pagina 23)

6 Operating Modes

Scan Mode

The imager can be set to operate in one of several scanning modes. See the HP Imaging Barcode

Scanner Product Reference Guide (PRG) for more information and settings for any of the options:

Trigger Single (Default): This mode is associated with typical handheld scanner operation. Motion

Sense is active and if the scanner detects motion the aiming pattern is turned on. When the trigger is

pulled, illumination is turned on and the scanner attempts to read a label. Scanning is activated until

one of the following occurs:

●

the programmable “maximum scan on time”

has elapsed

● a label has been read

●

the trigger is released

Trigger Pulse Multiple: Scanning begins when the trigger is pulled and continues after the trigger is

released, until the trigger is pulled again or until the programmable “maximum scan on time”

has

elapsed. Reading a label does not disable scanning. Double Read Timeout

prevents undesired

multiple reads while in this mode.

Trigger Hold Multiple: When the trigger is pulled, scanning starts and the product scans until the

trigger is released or “maximum scan on time”

has elapsed. Reading a label does not disable

scanning. Double Read Timeout

prevents undesired multiple reads while in this mode.

Always On — The illuminator is always ON and the scanner is always ready for code reading.

Double Read Timeout

prevents undesired multiple reads.

Flashing — The scanner illuminator flashes on and off regardless of the trigger status. Code reading

takes place only during the Flash On

time. Double Read Timeout

prevents undesired multiple reads.

See the PRG for these and other programmable features.

Controlled by Flash On Time and Flash Off Time. Use the PRG to program these options.

Stand Mode: In Stand Mode, the illumination remains on for a configurable amount of time after a

good read occurs. The scanner exits stand mode when movement is detected. If the trigger is

activated from stand mode, the scanner transitions into one of the triggered modes.

Pick Mode: Specifies a Decoding and Transmission process where bar codes that are not within the

configurable distance from the center of the aiming pattern are not acknowledged or transmitted to

the host. Pick Mode is active only while the scanner is in Trigger Single mode. If the scanner switches

to a different Read Mode, Pick Mode is automatically disabled.

Figure 6-1 ENTER/EXIT PROGRAMMING MODE

ENWW Scan Mode 17

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 36 37

Comentarios a estos manuales

Sin comentarios

HP rp5800 Manual de usuario Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Lectores De Códigos De Barras HP rp5800