Hp Smart Array P600-Controller Manual de usuario descargar pdf (Pagina 11)

Installing the controller hardware 11

CAUTION: Do not operate the server for long periods with the access panel open or removed.

Operating the server in this manner results in improper airflow and improper cooling that can

lead to thermal damage.

5. If the added drives are not hot-pluggable, power up the system.

Connecting external storage

1. Power down the server.

2. Connect an external SAS cable to the external port of the controller.

NOTE: You do not have to disconnect any internal drives on shared internal port 1I because

the controller preferentially discovers devices attached to port 1E. However, drives on the

shared internal port are unavailable until you disconnect the external storage device.

3. Tighten the lock screws on the cable connector.

4. Attach the other end of the cable to the SAS input connector of the external storage enclosure.

IMPORTANT: Drives that are to be used in the same array must be of the same type, either all

SAS or all SATA. (Parallel SCSI drives cannot be used with this controller.)

5. Tighten the lock screws on the cable connector.

6. Power up the enclosure.

7. Power up the server.

SAS cable part numbers

NOTE: If you require additional cables, order them by the option kit number.

SAS cable type Cable length Option kit number Cable assembly number

External cable 1.0 m (3.3 ft)

2.0 m (6.6 ft)

4.0 m (13 ft)

6.0 m (20 ft)

389665-B21

389668-B21

389671-B21

389674-B21

361317-001

361317-002

361317-004

361317-006

Internal wide cable depends on the

server

refer to the server

documentation

361316-00x

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 37 38

Sin comentarios

Hp Smart Array P600-Controller Manual de usuario Pagina 11