HP Compaq dc7600 Guía de usuario descargar pdf (Pagina 43)

Hardware Reference Guide www.hp.com 2–27

Hardware Upgrades

Installing a SATA Hard Drive into a 3.5-inch Drive Bay

✎

If you are replacing a hard drive, make sure to back up the data on the

old hard drive before removing it so that you can install the data onto

the new hard drive.

✎

HP does not support connecting both SATA and 3.5-inch PATA hard

drives on the same system.

To install a hard drive in a 3.5-inch drive bay:

1. If you have locked the Smart Cover Lock, restart the computer

and enter Computer Setup to unlock the lock.

2. Turn off the computer properly through the operating system and

turn off any external devices. Disconnect the power cord from the

power outlet and remove the computer access panel.

3. Install four 6-32 standard guide screws, two on each side of the

drive.

Installing the Hard Drive Guide Screws

✎

The hard drive uses 6-32 standard guide screws. Four extra guide

screws are installed on the hard drive bracket under the access panel.

The HP-supplied standard screws are silver. All other drives use M3

metric screws, eight of which are installed on the diskette drive

bracket under the access panel. The HP-supplied metric screws are

black.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 68 69

Sin comentarios

HP Compaq dc7600 Guía de usuario Pagina 43