
Hardware options installation 50
5.
Install the TPM board. Press down on the connector to seat the board ("System board components"
on page 10).
6. Install the TPM security rivet by pressing the rivet firmly into the system board.
7. Install the access panel (on page 17).
8. Install the server blade ("Installing a server blade" on page 29, "Remove the server blade" on page
16).
9. Power up the server blade (on page 15).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of
system integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
• Always store the recovery key/password in multiple locations.
Comentarios a estos manuales