Hp LH 3r Manual de usuario Pagina 1

HP NetServer LH 3rInstallation GuideforCompaq® 4000/7000 RacksHP Part Number 5967-5208Printed in July 1998

Chapter 2 Overview6Terms used in this document are defined in the table below.TermDefinitionBar nut Short, threaded bar used behind slide mounting fla

73 InstallationThis section contains detailed instructions for installing an HP NetServer LH 3rin certain models of Compaq rack enclosures.Preparatio

Chapter 3 Installation822nd20th(At RearOf Column)22nd20th22nd22nd20th20th15th11th19th14thFigure 3-1. Marking Holes for InstallationYou will mark two

Chapter 3 Installation9Installing the Bar Nuts, Screws, and Rack NutsOnce you have marked the appropriate holes, install the bar nuts and screws onthe

Chapter 3 Installation10Mounting the Slides1. Orient each slide so that the front of the slide attaches to the front columnand the rear attaches to th

Chapter 3 Installation11Push In and UpFigure 3-4. Mounting a Slide to a ColumnInstalling the NetServer1. Extend the slides until you hear a click, in

Chapter 3 Installation123. Using two people, lift the NetServer using the handles on each side. Movethe NetServer in between the extended slide member

Chapter 3 Installation13Figure 3-6. Attaching the Slides to the Server Chassis

Chapter 3 Installation145. Remove the two screws from each of the four handles and remove them(see Figure 3-7). Keep these handles and screws for late

Chapter 3 Installation15To install these brackets:1. On both slide members, simultaneously depress the lockout releases andpush the NetServer complete

iiNoticeThe information contained in this document is subject to change without notice.Hewlett-Packard makes no warranty of any kind with regard to th

Chapter 3 Installation162. Install the two screws that hold the tall, left-hand bracket to the face of theNetServer chassis (see Figure 3-9). 3. Ins

174 Warranty and SupportRefer to the warranty statement provided with your original HP NetServer systemdocumentation for the warranty limitations, cus

Chapter 4 Warranty and Support18HP Repair and Telephone SupportRefer to the Service and Support chapter of your HP NetServer systemdocumentation for i

19IndexCCompaq, 1Ffastening server to rack front, 14fastening server to slides, 12Hhandlesremoving after mounting, 14Llifting server into rack, 12lock

iiiContents1 Introduction ... 1HP NetServer LH 3r – Com

11 IntroductionThis document describes how to mount an HP NetServer LH 3r into a Compaq®model 4000- or 7000-series rack enclosure. Refer to the HP Ne

Chapter 1 Introduction2WARNING To prevent the rack from tipping over and causing equipmentdamage or bodily injury, be sure that the stabilizing, anti-

Chapter 1 Introduction3Figure 1-2. Single Rack Enclosure With the Anti-Tip StabilizingFeature Installed

Chapter 1 Introduction4HP NetServer LH 3r – Compaq Rack PrecautionsCAUTION If this NetServer is not installed according to theseinstructions, damage t

52OverviewThe steps required to install the NetServer in the rack are summarized below:NOTE This is only a summary; detailed instructions are provided