
M2 Speaker always on
M3 Speaker off during dialing, on until carrier detected
O0 Speaker online to data mode
O1 Issue a retrain before returning to Data Mode
P Pulse dial
Q0 Result codes enabled
Q1 Result codes disabled
T Tone dial
V0 Display results codes as digits
V1 Display result codes as text
Y0 Disable long space disconnect
Z0 Reset & recall user profile 0
Z1 Reset & recall user profile 1
&F Load factory default configuration
&M0 Asynchronous mode operation
&S0 DSR always ON
&S1 DSR comes on when establishing a connection
and goes off when the connection ends
&V View active profile
&W0 Store active profile as Profile 0
&Y0 Select profile 0 upon Power on or reset
&Zn=x
Store phone number x in into non-volatile RAM,
n=0-3
\N0 Buffer mode, no error control
\N1 Direct mode
\N2 MNP reliable mode
\N3 V.42, MNP, or buffer mode (autoreliable mode)
\N4 V.42 mode or disconnect
\Q0 Disable flow control
\Q1 XON/XOFF software flow control
\Q3 RTS/CTS hardware flow control
\Tn Inactivity timer, n-0-255
\V0 Disable protocol result code appended to DCE
speed
\V1 Enable protocol result code appended to DCE
speed
Section Four - Support and Service
NOTE: If after trying the recommended troubleshooting tips, you are
unable to isolate or resolve a problem, you should consult your
computer dealer.
Section Five - Technical Specifications
Modulation Std.:
V.90, K56flex, V.42bis, V.42, V.34, V.32bis, V.32, V.29,
V.27ter, V.22bis,V.22, V.21, V.17, Bell212/103
Temperature: 0 to 55 degrees C, operating; -20 to 80 degrees C, non-
operating
Compression: MNP 5, 4, 3, 2
Host Interface: PCI Bus socket, PCI spec version 2.1
COM ports: 1, 2, 3, 4, 5
IRQ lines: 3, 4, 5, 7, 9, 10, 11, 12
FAX Group: Group III
FAX Command: Class 1
Comentarios a estos manuales