HP D2D2502i Guía de usuario descargar pdf (Pagina 73)

net show config

NOTE: This command applies to multinode products only.

Description of Command Function

Shows the network configuration.

Command Syntax

net show config

Command Authority

Operator and Administrator

Command Object Requirements

Not applicable – no objects exist within this command.

Command Parameter Requirements

Not applicable – no parameters exist within this command.

Requirements for Command Execution

The command entry must conform to the command syntax.

Successful Command Output

Upon successful completion of the command, information on the external network configuration is

displayed.

Command Operation during Abnormal Conditions

If the command does not conform to the required syntax, the following is displayed:

Command Failed - the command does not conform to the required syntax,

SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this

section.

Example

# net show config

External Network Configuration

------------------------------

Template 2

Management/Data/Replication on (4) 1Gb ports (bonded)

Virtual Management Console IP Address: 16.24.164.21

1GbE Network Bonding

Mode 6 - Active Load Balance Bonding

Node Specific Parameters

------------------------

Node 1:

1GbE Network Physical IP (HP Service Only): 16.24.164.22

1GbE Network Virtual Data IP: 16.24.164.23

Node 2:

1GbE Network Physical IP (HP Service Only): 16.24.164.24

1GbE Network Virtual Data IP: null

Appliance Wide Parameters

-------------------------

1GbE subnet mask: 255.255.240.0

Data/Management network gateway: 16.24.160.1 (default)

net show config 73

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 177 178

Comentarios a estos manuales

Sin comentarios

HP D2D2502i Guía de usuario Pagina 73

Comentarios a estos manuales

Relacionado con productos y manuales para Gateways / Controladores HP D2D2502i