HP Access Control Software Manual de usuario descargar pdf (Pagina 8)

August 2017

FS4 devices with HP AC versions prior to 15.3.1

5. Hold on upgrading from original 15.2.x device agents until all server upgrades are complete.

NOTE: if using the X3D03A /HIP II reader, is going to be used for more than 2 card types, then the HPAC

devices agents for the devices using that reader will need to be upgraded.

2.9 Licensing

Licenses are retained across an upgrade. However, for disaster recovery purposes, a best practice is to keep a

record of the software licenses. HP can also provide replacement licenses if needed.

If new servers will be introduced, new licenses may be required. Consult with HP if this is a requirement for the

upgrade/migration.

2.10 AlertX

If AlertX is being used to monitor service failures, it should be stopped prior to the upgrade. If allowed to

continue running, AlertX will be triggered during the upgrade which could have negative consequences

depending on how it is being used. Refer to the AlertX documentation or contact HP Support if you need

instructions on disabling AlertX.

2.11 Testing prior to upgrade

RECOMMENDED: HP strongly recommends qualification of the new HP AC version and the upgrade process in a

non-production part of the customer’s environment before deployment to the production environment.

3 Upgrading HP Access Control

Perform the following steps to upgrade HP Access Control:

3.1 Upgrade device firmware if necessary

3.2 Upgrade HP AC client software on end user PCs

3.3 Upgrade HP AC server

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 16 17

Sin comentarios

HP Access Control Software Manual de usuario Pagina 8