HP OMEN - 17-w200 CTO Manual de usuario descargar pdf (Pagina 41)

5 Removal and replacement procedures for

Customer Self-Repair parts

This chapter provides removal and replacement procedures for Customer Self-Repair parts.

NOTE: The Customer Self-Repair program is not available in all locations. Installing a part not supported by

the Customer Self-Repair program may void your warranty. Check your warranty to determine if Customer

Self-Repair is supported in your location.

Component replacement procedures

NOTE: Details about your computer, including model, serial number, product key, and length of warranty,

are on the service tag at the bottom of your computer. See Labels on page 15 for details.

NOTE: HP continually improves and changes product parts. For complete and current information on

supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then

follow the on-screen instructions.

There are two screws that must be removed, replaced, and/or loosened when servicing Customer Self-Repair

parts. Make special note of the screw sizes and locations during removal and replacement.

Service door

Description Spare part

number

Service door, memory access 908719-001

Before removing the service door, follow these steps:

1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect the power from the computer by rst unplugging the power cord from the AC outlet and then

unplugging the AC adapter from the computer.

3. Disconnect all external devices from the computer.

Remove the service door:

1. Release the two captive Phillips screws (1) securing the service door to the base enclosure.

Component replacement procedures 29

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 100 101

Sin comentarios

HP OMEN - 17-w200 CTO Manual de usuario Pagina 41