Hp OmniBook 2100 Notebook PC Manual de usuario descargar pdf (Pagina 7)

Using OmniBook Plug-In Modules

6ITPEGMRKE4PYK-R%GGIWWSV]1SHYPI

1-7

Replacing a Plug-In Accessory Module

2SXI

• For Windows 95/Windows 98, if Agaté Tioman hot-swap software is installed, a

plug-in module icon appears at the right end of the taskbar. This software lets

you swap most plug-in modules without shutting down the computer.

• If you are removing or inserting a hard disk drive in the module bay, you must

shut down the computer.

• If you are removing a battery and inserting another battery, you do not have to

do steps 1 and 2 below—you can just change the batteries.

'%98-32

-J]SYEVIMRWIVXMRKSVVIQSZMRKE'(631HVMZI(:(HVMZISVER]SXLIVX]TISJ

HVMZI]SYQYWXYWIXLILSXW[ETWSJX[EVISVWLYXHS[RXLIGSQTYXIVSXLIV[MWI

]SYGSYPHPSWIHEXE

1. Close all files that are open from the plug-in module.

2. If the plug-in module icon is present in the taskbar, right-click the icon, then

click Remove Device. When prompted to remove the module, click OK. (You

do not have to do this if the bay is empty or contains a battery.)

–or–

Click Start, Shut Down to shut down the computer.

3. Slide the safety latch for the plug-in module bay into its recess.

4. Slide and hold the release latch, then pull out the module, as shown.

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Sin comentarios

Hp OmniBook 2100 Notebook PC Manual de usuario Pagina 7