Hp OmniBook 7100 Notebook PC Manual de usuario descargar pdf (Pagina 21)

Troubleshooting

7SPZMRK4VSFPIQW[MXL4PYK-R1SHYPIW

1-21

Solving Problems with Plug-In Modules

If your OmniBook plug-in module doesn’t seem to work properly, find the symptom

below that matches your situation. Try the suggestions one at a time.

This section separates problems into the following categories:

♦ CD-ROM / floppy drive problems.

♦ LS-120 drive problems.

♦ DVD drive problems.

♦ Battery problems.

CD-ROM / Floppy Drive Problems

If the CD-ROM drive stops responding

• Remove and reinsert the CD-ROM disk.

• Reset the OmniBook.

• Remove and reinsert the CD-ROM / floppy drive module.

If you cannot boot from a CD in the CD-ROM drive

• Check that the CD is bootable.

• Reset the OmniBook.

• Remove and reinsert the CD-ROM / floppy drive module.

• Run the BIOS Setup utility to make sure that the CD-ROM drive is the first boot

device. See the OmniBook Reference Guide for instructions on running the BIOS

Setup utility.

If the floppy drive doesn’t work

• Remove and reinsert the floppy disk.

• Remove and reinsert the CD-ROM / floppy drive module.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 32 33

Sin comentarios

Hp OmniBook 7100 Notebook PC Manual de usuario Pagina 21