HP Omnibook XE3 Manual de usuario Pagina 62

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 116
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 61
2-34 Removal and Replacement HP OmniBook XE3
Removing the Motherboard or Bottom Case
(HP Authorized Service Providers Only)
Required Equipment
Small Phillips screwdriver.
5mm socket driver.
When Installing a New Motherboard
Before replacing the motherboard, you must (if possible) electronically store the motherboard’s serial
number and service ID for transfer to the new motherboard.
1. Exit Windows and boot to a DOS prompt:
For Windows 98 or ME, press F8 during reboot and select Command Prompt Only.
For Windows 2000, boot from a DOS boot floppy disk.
2. Run ESN.EXE from one of these sources:
On a factory software installation, change to the \HP\Drivers\Hputils directory and type
esn at
the prompt.
Otherwise, copy \HP\Drivers\Hputils\ESN.EXE from the Recovery CD, then run it on the
notebook.
3. Save the serial number and service ID.
Vista de pagina 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 115 116

Comentarios a estos manuales

Sin comentarios