HP Server tc2100 Guía de instalación descargar pdf (Pagina 19)

Chapter 2 Installing Microsoft Windows NT 4.0 Server

NOTE The installation of the new network adapter will not take effect

until you restart the server.

If you want to implement Adapter Teaming (requires 2

Network Adapters), Windows NT 4.0 Service Pack version 6a

or above is required.

If there are errors during the installation, you should verify you

installed the correct driver for your adapter.

HP NetRAID-1M Adapter

1. Create the HP NetRAID driver for Windows NT diskette using the Navigator

CD provided with your NetRAID card. You may refer to the NetRAID card

manuals or HP Navigator CD for additional details.

2. Open Control Panel | SCSI Adapters | Drivers tab.

3. Select Add.

4. Click Have Disk when given a list of SCSI Adapters drivers then browse the

A: drive to locate the appropriate NetRAID-1M driver (in directory

A:\NETRAID). Click OK to install it.

5. Select the "Hewlett-Packard NetRAID 1M Adapter", and click

OK.

6. In the System Settings Change windows, click Yes to restart Windows NT.

NOTE If you do not restart the system at this point, the HP NetRAID-

1M Adapter driver will not be present in the driver list until the

next system boot.

Troubleshooting

This section will help you resolve some of the most common installation

problems.

Tip #1. Troubleshooting SCSI Host Bus Adapter Configuration

The boot manager for Windows NT contains recovery logic to allow you to return

to the last known good configuration. If you have changed your SCSI host bus

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Sin comentarios

HP Server tc2100 Guía de instalación Pagina 19