HP 7500A Guía de usuario descargar pdf (Pagina 115)

Solution 3: Ensure that the rear access panel is securely installed

Solution: Make sure that the rear door is securely installed.

If you removed the rear door to clear a paper jam, replace it. Gently push the door

forward until it snaps into place.

Cause: The rear door was not securely installed.

Ink streaks on the back of the paper

Try the following solutions if there is smeared ink on the back of your printout.

•

Solution 1: Print on a page of plain paper

•

Solution 2: Wait while the ink dries

Solution 1: Print on a page of plain paper

Solution: Print one or several pages of plain paper to soak up any excess ink in

the printer.

To remove excess ink using plain paper

1. Load several sheets of plain paper in the input tray.

2. Wait five minutes.

3. Print a document with little or no text.

4. Check the back of the paper for ink. If there is still ink on the back of the paper,

try printing on another page of plain paper.

Cause: Ink accumulated inside the printer, where the back of the paper rests during

printing.

If this did not solve the issue, try the next solution.

Solution 2: Wait while the ink dries

Solution: Wait at least thirty minutes for the ink inside the printer to dry, then try the

print job again.

Cause: The excess ink in the printer needed to dry out.

Poor black text

Try the following solutions if the text in your printouts is not sharp and the edges are rough.

•

Solution 1: Wait before you attempt to reprint

•

Solution 2: Use TrueType or OpenType fonts

•

Solution 3: Align the printhead

•

Solution 4: Clean the printhead

Solution 1: Wait before you attempt to reprint

Solution: If the black cartridge is new, allow time for automatic servicing to clear

up the problem. Black print quality should start to improve in a few hours. If you do

Print quality troubleshooting 111

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 251 252

Sin comentarios

HP 7500A Guía de usuario Pagina 115