HP ProCurve Series Manual de usuario descargar pdf (Pagina 32)

2-10

Installing the Switch

Installation Procedures

Installing the Switch

Removing the mini-GBICs:

Note You should disconnect the network cable from the mini-GBIC before removing

it from the switch.

Depending on when you purchased your ProCurve mini-GBIC, it may have

either of three different release mechanisms: a plastic tab on the bottom of

the mini-GBIC, a plastic collar around the mini-GBIC, or a wire bail.

To remove the mini-GBICs that have the plastic tab or plastic collar, push the

tab or collar toward the switch until you see the mini-GBIC release from the

switch (you can see it move outward slightly), and then pull it from the slot.

To remove the mini-GBICs that have the wire bail, lower the bail until it is

approximately horizontal, and then using the bail, pull the mini-GBIC from the

slot.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 109 110

Sin comentarios

HP ProCurve Series Manual de usuario Pagina 32