HP 100BaseT Guía de usuario descargar pdf (Pagina 46)

HP 100Base-T Hubs Installation and Reference Guide

2-14 Installing the System

Verifying Port Status

Check each connection by viewing the port status indicators

listed below. (For a more detailed description on these

indicators, refer to Chapter 5.)

/(' &RORU

6WDWH

,QGLFDWLRQ

/LQN JUHHQ 2Q 3RUWKDVHVWDEOLVKHGDYDOLGQHWZRUN

FRQQHFWLRQ7KH5-SOXJKDVEHHQSURSHUO\

VHDWHGLQWKH5-SRUW

7UDIILF JUHHQ %OLQNLQJ 7UDIILFLVWUDYHUVLQJWKHSRUW

7[5[ JUHHQ %OLQNLQJ 7UDIILFLVWUDYHUVLQJWKHSRUW

 JUHHQ 2Q &RPPXQLFDWLRQVKDYHEHHQVHWWRDVSHHGRI

0ELWV

)'; JUHHQ 2Q &RPPXQLFDWLRQVKDYHEHHQVHWWRIXOOGXSOH[

PRGH

1. The indicator appears on the front of the 10/100TX Switch Port Module.

Table 2.4 Checking Key LED Indicators

If the Link status indicator is not functioning properly, or you

experience any other difficulties in setting up the switch, refer

to Appendix A.

Verifying System Operation

Verify that all attached devices have a valid connection. The

hub monitors link status for each port. If any device is properly

connected to the hub and transmitting a link beat signal, the

Link indicator lights for the corresponding port. If the Link

indicator fails to light when you connect a device to the hub,

check the following items:

• Be sure the media cable is properly attached to the connected

device and the hub. Verify that the cable connector snaps

into place when attached.

• See if the media cable is functioning properly by using it for

another port and attached device that displays valid

indications when connected to the network.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 156 157

Sin comentarios

HP 100BaseT Guía de usuario Pagina 46