HP E5000 Guía de usuario descargar pdf (Pagina 96)

Replacing the front bezel (full)

1. Install the replacement front bezel with the handle at a 90 degree angle, making sure the

bottom pins are aligned with the bottom holes (1, Figure 90 (page 96)), and replace the

screws in the front bezel (2).

NOTE: There are two screws on the bottom, four screws on the sides (two on each side),

and two screws hidden behind the handle.

Figure 90 Replacing the front bezel

2. Close the drive handle.

3. Push the drive drawer back into the system enclosure.

4. Replace the enclosure as described in “Inserting the system enclosure into the rack” (page 76).

Removing and replacing the front LED display board in the rack (standard)

NOTE: If you are not able to access all of the screws due to the enclosure position in the rack,

use the full procedure instructions.

Removing the front LED display board in the rack

1. Verify the failed component as described in “Verifying component failure” (page 73).

2. Power off the system as described in “Powering the system off and on” (page 67).

3. Remove the front bezel as described in “Replacing the front bezel” (page 94).

96 Removing and replacing hardware components

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 198 199

Sin comentarios

HP E5000 Guía de usuario Pagina 96