HP Printer PCLA8205B Manual de usuario descargar pdf (Pagina 23)

3 Connecting to a Windows NT Server 3.51

Windows 95 SR2

Windows 95 SR2 Requirements

• HP Vectra with Windows 95 SR2

• Intel EtherExpress PRO 10+ ISA Ethernet card and drivers disk.

• Driver Name: PROW95.VXD Size: 6K Date: 8/7/96

• Microsoft Windows NT Server 3.51 machine that supports Net BEUI,TCP/

IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

• Board Connector type Auto-detect

• Force 8-bit operation Yes

• Flash chip address Disabled

• Remote boot program None

Procedure

1 With the HP Vectra turned off, install the Intel EtherExpress PRO 10+ ISA

adapter card into an ISA slot.

2 Connect network cable media to the Intel EtherExpress PRO 10+ ISA

card.

3 Insert a DOS bootable diskette and power on the machine.

4 After booting, insert the Intel EtherExpress drivers disk, “EtherExpress

drivers Ver. 3.5”, and execute “A:\SOFTSET2.EXE.”

5 Select “Configure NIC”, and verify the resource settings listed above

under the heading “Device Configuration.”

6 If changes are required, save those changes and exit.

7 Remove the Intel EtherExpress software driver diskette and reboot the

machine.

8 Power on the machine and allow it to boot to Windows 95.

Vectra VL8 Vectra VL7 Vectra VE7/VE8

I/O Address 210-21Fh 210-21Fh 300-30Fh

Interrupt 10 10 11(16 bit only)

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 48 49

Sin comentarios

HP Printer PCLA8205B Manual de usuario Pagina 23