HP 4400 Guía de instalación descargar pdf (Pagina 22)

Figure 10 Securing the rear of the enclosure in the rack (view from front of rack)

4. Reattach the front bezel covers.

5. At the rear of the rack, loosen the thumbscrew on the shipping retaining bracket (1, Figure 11)

and slide the bracket forward (2) until the tab engages the slot in the chassis. Tighten the

thumbscrew on the bracket.

Figure 11 Securing the rear of the enclosure (view from rear of rack)

6. Repeat 1 through 5 to install the controller enclosures.

Installing the hard drives into the drive bays

After the disk enclosures are secured in the rack, install the hard drives into the drive bays. Drives

must be installed in the proper bay sequence (see Figure 12) in the enclosures for optimum HP

Command View EVA performance and data integrity.

For example, if you have four enclosures, and eight drives, you should install four drives into bay 1

of each enclosure and four drives into bay 2 of each enclosure. Do not install all the drives into

enclosure 1 and leave the other enclosures empty.

Install components22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Sin comentarios

HP 4400 Guía de instalación Pagina 22