HP 5300 Guía de instalación descargar pdf (Pagina 11)

HP ProCurve Switch xl Modules

Features

■ Module Ready LED—This LED comes on after the module completes the

boot up and self test processes and indicates the module is up and running.

■ Mode (selected on switch)—These LEDs operate in conjunction with the

Mode Select button on the switch chassis to show port activity, duplex

mode and link speed. For example, if you have selected “Act” with the

Mode Select button on the chassis, then the two Mode LEDs on the module

(Downlink and Uplink) will blink if there is activity on those ports. For

more information refer to LEDs on Page 1-6 of the HP ProCurve Series

5300xl Switches Installation and Getting Started Guide.

■ Module Activity (10%, 50%, 80%)—These LEDs come on according to the

amount of activity or load the module is experiencing. For example, 10%

indicates that the module has a light load, however, 80% indicates that the

module is nearing work load saturation.

■ Module Fault—This LED (colored orange) comes on when there is an

error condition detected in the module.

Battery Installation Required

The Access Controller xl Module (J8162A) ships without the clock battery

installed. You must insert the battery before installing the module into the

switch. See the following graphic for instructions.

Insert the battery with the lettering

and the plus “+” sign facing up.

Battery Slot

Battery

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Sin comentarios

HP 5300 Guía de instalación Pagina 11