HP BL2x220c - ProLiant - G5 Server A Guía de usuario descargar pdf (Pagina 15)

Operations 15

To remove the component:

Power down the server blade (on page 13).

Remove the server blade (on page 14).

Place the server blade on a flat, level work surface with the bezel facing away from you.

Extend the server B serial label pull tab.

CAUTION: The jackscrews control the unseating and seating of critical system connectors.

Failure to use the jackscrews to remove and install the server B assembly can cause the system

boards to fail.

Turn jackscrew 1 approximately six turns counterclockwise.

Turn jackscrew 2 counterclockwise until the threads are fully disengaged.

Turn jackscrew 1 counterclockwise until the threads are fully disengaged.

CAUTION: To prevent damage to the server blade, do not apply pressure to the enclosure

connector.

Lift server B assembly from server A assembly, and then place it on the work surface with the system

board facing up.

Install server B assembly

For access component identification, see "Access components (on page 11)."

Extend the server B serial label pull tab.

Engage the front edge of server B assembly with the front edge of server A assembly.

CAUTION: Route the cache module battery cables so that they do not become pinched when

the server B assembly is installed.

Lower server B assembly onto server A assembly.

Align the signal and power connectors on server B assembly with the corresponding connectors on

server A assembly.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 91 92

Sin comentarios

HP BL2x220c - ProLiant - G5 Server A Guía de usuario Pagina 15