HP Blade Workstation Client Guía de inicio rápido descargar pdf (Pagina 32)

28 www.hp.com Getting Started

Getting Started

Red Power LED

flashes four

times, once every

second, followed

by a two-second

pause. The beeps

continue for five

iterations, then

stop. The LED

flashes continue

until the problem

is resolved.

4 Power failure

(power supply is

overloaded).

1. Open the hood and

ensure the 4-wire

power supply cable

is seated into the

connector on the

system board.

2. Check if a device is

causing the problem

by removing ALL

attached devices

(such as hard,

diskette, or optical

drives, and

expansion cards).

Power on the system.

If the system enters

the POST, then power

off and replace one

device at a time and

repeat this procedure

until failure occurs.

Replace the device

that is causing the

failure. Continue

adding devices one

at a time to ensure all

devices are

functioning properly.

3. Replace the power

supply.

4. Replace the system

board.

Diagnostic Front Panel LEDs and Audible Codes

Activity Beeps

Possible

Cause

Recommended

Action

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38

Comentarios a estos manuales

Sin comentarios