HP LH3000r - NetServer - 128 MB RAM Guía de instalación Pagina 12
- Pagina / 182
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 1 Setting Up the HP NetServer LH 3000r and LH 3000
4
14. Install the Cable Management Arm to the rear of the rack-mounted
HP NetServer.
Refer to Chapter 8, "Mounting the HP NetServer in the Rack System/E or
Rack System/U."
15. Hook up the monitor, keyboard, mouse, and power supplies, if any.
Refer to Chapter 9, "Connecting Monitor, Keyboard, Mouse, and Power
Supplies," and to the power supply installation guide.
16. Connect external cables.
17. Power up the HP NetServer.
Refer to Chapter 2, "Controls, Ports and Indicators."
18. Go to the "Configuring the HP NetServer" section later in this chapter.
Pedestal Installation
Follow the setup steps in the exact order shown below for a successful pedestal
installation. Skip any steps that do not apply to your installation.
Figure 1-3. LH 3000 and Bezel
CAUTION Unlock bezel before removing it.
1. As you unpack the shipping box, verify contents against the Contents List
included with your HP NetServer. If anything is missing or damaged, call
your reseller.
- HP NetServer 1
- LH 3000/3000r 1
- Installation Guide 1
- Contents 3
- 1 Setting Up the HP NetServer 9
- LH 3000r and LH 3000 9
- Rack Mount Installation 10
- Pedestal Installation 12
- Configuring the HP NetServer 14
- ◊ Restart the HP NetServer 15
- ◊ Install NOS: 17
- Introduction 19
- Front of the Chassis 19
- Front Panel Console 20
- RESET 21
- Viewing System Information 22
- Main Menu 22
- Event Log Menu 23
- HW System Info Menu 25
- Component Info Menu 26
- Service Menu 26
- Adjust Contrast Menu 27
- Rear of the Chassis 28
- Figure 2-7. Onboard LEDs 30
- Table 2-4. PCI Hot Plug LEDs 31
- Table 2-5. Power Supply LEDs 31
- • In Europe: 32
- Power-On Tests 33
- Power-Up Procedure 33
- Power-Down Procedure 33
- Sleep States (ACPI) 34
- 3 Opening and Closing the HP 37
- NetServer 37
- Removing the LH 3000r Covers 38
- Figure 3-5. Remove Z-bracket 40
- Figure 3-6. Locking Latch 41
- Replacing the LH 3000r Covers 43
- Removing the LH 3000 Covers 44
- Thumbscrew 45
- Mass Storage Guidelines 48
- SCSI Termination 49
- Primary Cage - SCSI A 49
- Secondary Cage - SCSI B 50
- Secondary 52
- Boot Priority 53
- Drive Spacer 55
- Locking Latch 56
- Connecting SCSI Sub-Systems 60
- Memory Guidelines 61
- LH 3000LH 3000r 63
- Rotate retaining latches 64
- Align DIMM notches 65
- Guidelines 68
- Remote Control Board 69
- IRQ Settings 69
- Tested PCI Boards and Drivers 70
- Installing Accessory Boards 70
- Front board hold-down 72
- Non Hot-Plug Slot 3 73
- Retainer 73
- Removing a Hot-Plug Board 76
- Configuration Guidelines 79
- Installing the Processor 80
- Blue Retaining Latches 81
- Terminator 84
- Release Levers 84
- Figure 7-6. Install Processor 85
- Figure 7-8. Insert the VRM 86
- Configuration 87
- Configuration Switches S5-S8 88
- Upgrading the Firmware 91
- Testing the Processor 91
- Removing a Processor Module 91
- Anti-tip 95
- Installing Bezel Rack Nuts 98
- Attaching the Slides 101
- Installing the HP NetServer 103
- Mouse, and Power Supplies 113
- Power Supplies 114
- HP NetServer Navigator CD-ROM 115
- Document 117
- Number 117
- Check the Readme File First 118
- Installation Assistant 119
- Configuration Assistant 119
- Express Configuration 119
- • Show System Information: 121
- • Configure Disk Array: 121
- • Install Utility Partition: 121
- • Execute Card Utilities: 121
- Custom Configuration 122
- NOS Installation 123
- HP Management Solutions 124
- TopTools Remote Control 125
- PcANYWHERE32 126
- NetServer Utilities 126
- Setup Utility 127
- Using the Setup Screens 129
- Power-On Password 131
- Hardware Security 131
- 1. [Bootable Cards] 135
- Clearing CMOS 136
- SCSI Configuration Utility 137
- 11 Information Assistant 139
- Installing from the CD-ROM 142
- 12 Troubleshooting 143
- Common Installation Problems 144
- Chapter 12 Troubleshooting 145
- DiagTools 147
- Error Messages 148
- 12345678 149
- Password Problems 150
- 13 Alternative Rack Mounting 151
- Preparing for Installation 153
- Tools Required 154
- Installing the Slides 154
- Installing Rack Nuts 156
- Installing Bar Nuts 157
- A Specifications 161
- Power Requirements 162
- 2D Video Modes 163
- 3D Video Modes 163
- B Regulatory Information 165
- Notice for Japan 167
- Notice for Korea 168
- Notice for Taiwan 169
- Notice for European Union 169
- Battery Statements 173
- C Service and Support 175
- Warranty 177
Relacionado con productos y manuales para Barebones Pc / Estación De Trabajo HP LH3000r - NetServer - 128 MB RAM
(2 paginas)
(2 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.142 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales