HP ML330 - ProLiant - G3 Guía de instalación descargar pdf (Pagina 30)

Server Operations

Removing the Front Bezel

CAUTION: To prevent equipment damage or data loss, be sure that the server is

powered down, all cables are disconnected from the back of the server, and the

power cord is disconnected from the grounded (earthed) AC outlet before removing

the front bezel.

To remove the front bezel:

1. Power down the server. Refer to “Powering Down the Server” in this chapter.

2. Pull up on the bezel locking latch until it disengages.

3. Rotate the bezel upward and slide it away from the chassis. A small amount of

force may be necessary to detach the bezel.

To replace the front bezel, reverse the removal procedure.

IMPORTANT: When replacing the front bezel, be sure to place the top hinge points in the

chassis before rotating the front bezel downward to its original position.

2-2 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide

HP CONFIDENTIAL

Writer: Rob Weaver File Name: c-ch2 Server Operations.doc

Codename: Flashback Part Number: 322383-001 Last Saved On: 2/11/03 1:21 PM

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 134 135

Sin comentarios

HP ML330 - ProLiant - G3 Guía de instalación Pagina 30