HP NetServer LH 3/LH Guía de instalación descargar pdf (Pagina 17)

Chapter 1 Processor Module Installation

Removing the Processor Module

If you are upgrading an existing processor module, you must first remove the

module from the slot.

To remove a processor module:

1. Press in on each processor module release latch until it remains in (see

Figure 1-11). If the latch does not stay in, you must hold it in while

removing the module.

2. Lift up on the processor ejector lever until the processor pops out of the

processor socket (see Figure 1-11).

CAUTION Do not move the processor ejector lever beyond its limit

(about 25-30 degree angle from horizontal). The ejector lever

may break if forced.

3. Remove the processor module from the mounting bracket assembly.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 33 34

Sin comentarios

HP NetServer LH 3/LH Guía de instalación Pagina 17