HP Vectra 486VL Guía de usuario descargar pdf (Pagina 12)

MS9530 Voyager RF Base Station - 11 - Printed: September 2002

Version: 1.1 Status: Approved

RS232C Mode

The installation of the Base Station requires the M-01 cable and a power

supply (figure 3). See page 2 - 5 for pin assigment.

To install the BASE STATION in RS232C Mode

follow these steps:

1 - Turn off power to the terminal

2 - Install the M-01 cable plugging the 8

pins modular connector to the port.

Plug the jack connector of the power supply.

3 - Power up the terminal and configure RS232C Base

Station parameters.

NOTE: To update the configuration, Base Station should be

powered off and on.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 83 84

Sin comentarios

HP Vectra 486VL Guía de usuario Pagina 12