HP Vectra XE310 Guía para resolver problemas descargar pdf (Pagina 26)

Upgrading and Replacing PC Hardware

Replacing the Power Supply Unit

WARNING Hewlett-Packard does not support power supply upgrades. This information is provided to help you replace a defective

power supply unit. For your safety, only replace with a power supply provided by HP support services.

To avoid electrical shock, do not open the power supply. There are no user-serviceable parts inside.

For your safety, disconnect the power cord and all external cables.

1 Switch off the PC, disconnect the power cord and remove the PC’s side panel and air flow guide (refer

“Removing and Replacing the Side Panel & Air Flow Guide” on page 12).

2 Remove the three screws from the rear of the PC.

Screws

Voltage switch

3 Disconnect all power cables from installed drives and from the system board.

4 Lift the power supply unit out of the PC.

5 Place the new power supply unit inside the PC and tighten the three screws on the rear of the PC.

6 Reconnect all the power cables to the drives and the system board.

7 Replace the PC’s side panel and air flow guide (refer to “Removing and Replacing the Side Panel & Air

Flow Guide” on page 12).

8 Check that the voltage switch is set correctly for your country (the voltage is set during manufacturing

and should already be correct).

9 Reconnect the power cord.

1 2 ... 21 22 23 24 25 26 27 28

Sin comentarios

HP Vectra XE310 Guía para resolver problemas Pagina 26