HP 61-in Manual de usuario descargar pdf (Pagina 71)

Passes Uni/

bidir

Self

adhesi

Banner Textile Film Synthet

paper

Paper

aqueou

Paper

solvent

Low

temp.

Mesh

18* Bidir Yes Yes Yes Yes Yes Yes Yes Yes Yes

20 to 32 Bidir Yes Yes Yes Yes Yes Yes Yes Yes Yes

* Unlike other printmodes, the 18-pass printmode has 1200 dpi x 1200 dpi input data resolution at 1

bpp (1 bit per pixel). Therefore, to generate a 18-pass media preset you should start either from an

existing 18-pass preset or from scratch. In the same way, do not clone an 18-pass media preset to

generate a preset with a print mode other than 18-pass.

Key

●

Bidir: bidirectional

●

No: not recommended

●

Maybe: may be worth trying for extra speed

●

Start here, Yes: recommended

NOTE: More specific settings for many substrates from different vendors are available in the HP

Media Finder at

http://www.hp.com/go/latexmediafinder/.

Check the quantity of ink on the substrate

Check that the ink quantities in your media preset are adequate. Look at the color patches in the HP

diagnostic chart and check that the patches have the correct amount of ink using the guidelines below:

1. Too much ink: There are several possible symptoms of this problem.

●

The last two or three scales of the chart look the same.

ENWW

Add a new substrate

Substrate settings

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 94 95

Sin comentarios

HP 61-in Manual de usuario Pagina 71