HP 6280 Información técnica descargar pdf (Pagina 137)

Solution: Clear the paper jam.

For more information, see:

“

Clear paper jams” on page 111

Cause: The print head assembly has stalled.

Solution: Turn the HP All-in-One off and open the ink cartridge door. Remove any

objects that are blocking the print head assembly (including any packing materials),

and then turn the HP All-in-One on again.

Cause: The HP All-in-One is out of paper.

Solution: Load paper in the input tray.

For more information, see:

“

Load paper” on page 36

The pages in my document came out in the wrong order

Cause: The print settings are set to print the first page of your document first.

Because of the way the paper feeds through the HP All-in-One, this means the first

page will be print side up at the bottom of the stack.

Solution: Print the document in reverse order. When the document finishes

printing, the pages will be in correct order.

For more information, see:

“

Print a multiple-page document in reverse order” on page 58

The margins are not printing as expected

Cause: The margins are not set correctly in your software application.

Solution: Check the printer margins.

Make sure the margin settings for the document do not exceed the printable area of

the HP All-in-One.

To check your margin settings

1. Preview your print job before sending it to the HP All-in-One.

2. Check the margins.

The HP All-in-One uses the margins you have set in your software application,

as long as they are greater than the minimum margins the HP All-in-One supports.

3. Cancel the print job if the margins are not satisfactory, and then adjust the margins

in your software application.

Cause: The paper size setting might not be set correctly for the project you are

printing.

Chapter 14

136 Troubleshooting

Troubleshooting

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 188 189

Sin comentarios

HP 6280 Información técnica Pagina 137