
HP All-in-One •
B1
a
b
c
a Locate the Ethernet cable that you purchased separately.
b Remove the yellow plug from the back of the device.
c Connect one end of the Ethernet cable to the Ethernet port on
the back of the device.
d Connect the other end of the Ethernet cable to the hub/route
switch.
e Continue to the next page.
Connect the Ethernet cable
Section B: Ethernet (wired) network
Important: Do not connect the Ethernet cable to a cable mode
You must have a working network. If you already connected the
USB cable, do not connect the Ethernet cable.
Comentarios a estos manuales