HP DesignJet 2000CP Manual de usuario descargar pdf (Pagina 83)

Working with Media

Installing a New Roll into the Printer

3-33

4 Place the spindle vertically on the floor, with the fixed spindle media guide at the

bottom. Take off the removable spindle media guide from the top of the spindle, and

slide the new roll onto the spindle. The leading edge of the media must wind

clockwise as shown below.

5 Install the removable spindle media guide onto the end of the spindle.

a Push down on the media guide, making sure that the guide is flush against the

ends of the roll.

b Then push the middle section in.

Correct Incorrect

C4723119

C4723132

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 208 209

Sin comentarios

HP DesignJet 2000CP Manual de usuario Pagina 83