HP FlexJet E Manual de usuario descargar pdf (Pagina 13)

Getting Started

Thank you for purchasing the Ioline FlexJet E or StudioJet printer.

This manual contains instructions and guidelines for setting up,

operating and maintaining your Ioline printer. The following compo-

nents are needed to create markers:

n A FlexJet E printer assembled according to the directions out-

lined in the FlexJet E Printer or StudioJet Quick Start Guide.

n A computer system that is properly installed and has a func-

tioning serial or USB port.

n Apparel design software loaded into the computer according to

the installation instructions.

n Printing media and ink cartridges that are within the guidelines

stated under the Operation chapter.

n Depending on the communications setup, Ioline FlexPlot soft-

ware is required if your CAD software does not create compat-

ible les.

In order to output to the FlexJet

E or StudioJet printer, your

apparel design software must

create plot les in HPGL 7475

or DM/PL format. Alternatively,

you can output markers using the

FlexPlot software, included with

the printer. FlexPlot imports and

converts a variety of le formats

for output to your Ioline printer.

Note

The Ioline Control Center

and FlexPlot will only run on

the Windows® 2000/XP/Vista

operating systems. Most design

software provides drivers for

Ioline printers. Contact Ioline

customer service if you need as-

sistance with drivers.

Note

Overview

Chapter 1

Unless otherwise noted, diagrams and descriptions de-

picting Ioline FlexJet E printer models also apply to the

Ioline StudioJet in this manual.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 70 71

Sin comentarios

HP FlexJet E Manual de usuario Pagina 13