
Status Description
The HP ePrint light is on. The HP ePrint feature is on and ready to use.
For more information, see Print with HP ePrint on page 45.
The HP ePrint light is o. The HP ePrint feature is o.
To turn on HP ePrint, press the HP ePrint button ( ).
The HP ePrint light blinks for three seconds, and then turns o. One of the following might have occurred.
● The Web Services have not been setup up.
● A mandatory update for the printer is available but has not
been installed.
● The HP ePrint feature has been disabled.
Press the HP ePrint button ( ) and the Information button
( ) at the same time to print a diagnostic page, and then
follow the instructions on the page.
The HP ePrint light keeps blinking. The HP ePrint feature is turned on, but the printer is not
connected to the Web Services server.
Press the HP ePrint button ( ) and the Information button
( ) at the same time to print a diagnostic page, and then
follow the instructions on the page.
Printhead icons and Printhead Alert light
● The Error icon, one of the Printhead icons, and the Printhead Alert light are blinking.
Cause Solution
One of the following might have occurred.
– The corresponding printhead is missing.
– The corresponding printhead is installed incorrectly.
– The corresponding printhead still has orange plastic tape
or the plug on it.
– If one of the printheads is missing, insert the
corresponding printhead.
– If both printheads are installed in the printer, remove the
corresponding printhead, make sure there is no plug or
plastic tape on it, and then reinsert the printhead
securely.
NOTE: After you have set up the printer, do not open
the printhead latch unless installing new printheads or
moving the printer outside your home or oice.
For more information, see Fix printhead problems
on page 89.
● The Error icon, both Printhead icons, and the Printhead Alert light are blinking.
ENWW Control panel lights and display icons status 11
Comentarios a estos manuales