HP ProDesk 498 G2 Microtower PC Manual de usuario Pagina 62

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 162
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 61
7. Reset the date and time, your passwords, and any special system setups using Computer Setup.
8. Lock any security devices that were disengaged when the computer access panel was removed.
DisplayPort connector module
1. Prepare the computer for disassembly (Preparation for disassembly on page 27).
2. Remove the access panel (
Access panel on page 28).
3. From the outside, rear of the computer, remove the Torx T15 screw that secures the DisplayPort
module to the computer.
NOTE: Chassis appearance may vary.
4. From the inside of the computer, pull the module straight up to disengage it from the system board
connector.
To reinstall the DisplayPort connector module, reverse the removal procedure.
52 Chapter 5 Removal and replacement procedures: Microtower
Vista de pagina 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 161 162

Comentarios a estos manuales

Sin comentarios