HP 2012i Manual de usuario descargar pdf (Pagina 48)

48 HP StorageWorks 2012i Modular Smart Array user guide • March 2008

3. In the terminal emulator, connect to controller A.

4. Press Enter to display the CLI prompt (#).

5. At the prompt, type the following command to set the values you obtained in Step 1

for each Ethernet management port, first for controller A and then for controller B:

where:

■ address is the IP address of the controller

■ netmask is the subnet mask

■ gateway is the IP address of the subnet router

■ a|b specifies the controller whose network parameters you are setting

For example:

6. Type the following command to verify the new IP addresses:

Network parameters, including the IP address, subnet mask, and gateway address

are displayed for each controller.

7. Disconnect from the CLI and exit the emulator.

set network-parameters ip address netmask netmask gateway gateway

controller a|b

# set network-parameters ip 192.168.0.10 netmask 255.255.255.0

gateway 192.168.0.1 controller a

# set network-parameters ip 192.168.0.11 netmask 255.255.255.0

gateway 192.168.0.1 controller b

show network-parameters

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 85 86

Sin comentarios

HP 2012i Manual de usuario Pagina 48