HP 4000M Manual de usuario descargar pdf (Pagina 151)

6-75

Configuring the Switch

Load Balancing: Port Trunking

Configuring the Switch

4. In the Group column, move the cursor to the port you want to configure.

5. Use the Space bar (or type the trunk name, such as trk5) to choose a trunk

assignment for the selected port.

• All ports in a trunk should have the same media type and mode (such

as 10/100TX set to 100HDx, or 100FX set to 100FDx). The flow control

and broadcast limit settings should also be the same for all ports in a

given trunk. To verify these settings, refer to “Port Settings” on page

6-30.

• You can configure up to ten different trunks (Trk1...Tr k 9,Tr k0), with one,

two, three, or four ports per trunk. A port can be assigned to only one

trunk. However, you can move ports between trunks. If multiple

VLANs are configured, all ports within a given trunk will be assigned

to the same VLAN or set of VLANs. (With the 802.1Q VLAN capability

built into the switch, more than one VLAN can be assigned to a trunk.

Refer to “Port-Based Virtual LANs (VLANs)” on page 6-51.)

(To return a port to a non-trunk status, keep pressing the Space bar

until a blank appears in the highlighted Group value for that port.)

Figure 6-50. Example of Trunk Group Assignments for Several Ports

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 303 304

Sin comentarios

HP 4000M Manual de usuario Pagina 151