Hp Insight Management-Software Manual de usuario descargar pdf (Pagina 124)

To correct this issue with a VC Domain, remove the VC Domain from VC Domain Group, break

the external manager lock and release these MAC, WWN, and serial number address ranges as

follows:

1. Telnet in to the VCM using an SSH connection such as SSH Administrator@xxx.xxx.xxx.xxx,

where xxx.xxx.xxx.xxx is the VC Domain IP address.

2. To determine the user name of the external manager account, from the VCM command prompt,

enter show external-manager. For this example, assume the user name returned was

xyz.

3. To disable the account, from the VCM command prompt, enter

set external-manager Username=xyz Enabled=false.

Perform the following:

• To remove the account and release the VC Domain from VCEM control, from the VCM

command prompt, enter

remove external-manager Username=xyz

mactype=<Factory-Default/User-Defined> MacStart=<> MacEnd=<>

wwnType=<Factory-Default/User-Defined> WwnStart=<> WwnEnd=<>

serverIdType=<Factory-Default/User-Defined> serverIdStart=<>

serverIdEnd=<>

NOTE: The “-quiet” option is used to suppress user confirmation prompts. This option is useful

for scripting operations. This option is available or later for the disable account, remove the

account, and release ranges commands.

For more information, see the HP Virtual Connect Manager Command Line Interface User Guide.

VC Domain displays Configuration Mismatch status

If the VCEM data does not match the data from the VC Domain, then the Configuration Mismatch

icon appears. This might happen when either the user suspends the external manager lock and

then modifies the VC Domain, or adds or removes VC Modules from rear-enclosure interconnect

bays.

To correct this issue, see “Resynchronizing a VC Domain with Configuration Mismatch” (page 49).

VC Domain displays Connectivity failure status

The Connectivity failure icon might appear if any of the following occur:

• Connection timeout, network problems, Virtual Connect Ethernet Modules physically not

available, or enclosure problem

• VCM failover

• VC Domain firmware update

• Virtual Connect Ethernet Module IP address change.

To correct this issue, perform any of the following:

• Ethernet VC modules are not physically available or there is a connection timeout or a network

problems between VCEM and VC Ethernet modules.

To correct this issue, verify the Ethernet VC Modules are still available and that there are no

network-related issues with the VCM. From the command line at the VCEM server, ping the

VC Domain IP.

124 Troubleshooting VCEM

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 146 147

Sin comentarios

Hp Insight Management-Software Manual de usuario Pagina 124