
ISDP Commands
CLI Command Reference
September 2014 Page 488
HP Moonshot Switch Module CLI Command Reference
show isdp neighbors
This command displays the list of neighboring devices.
Example: The following shows example CLI display output for the command.
(Routing) #show isdp neighbors
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge,
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Intf Holdtime Capability Platform Port ID
---------------------- ------------ --------- ------------ -------------------- ------------------
----
none 1/0/1 163 R BCM-56844 1/0/44
none 1/0/2 163 R BCM-56844 1/0/41
none 1/0/3 163 R BCM-56844 1/0/45
Example: The following shows example CLI display output for the command.
(Routing) #show isdp neighbors detail
Device ID none
Address(es):
Capability Router
Platform BCM-56844
Interface 1/0/1
Port ID 1/0/44
Holdtime 155
Advertisement Version 2
Time when last changed 0 days 03:18:35
Version :
8.6.5.4
Format
show isdp neighbors [{unit/slot/port | detail}]
Mode Privileged EXEC
Term Definition
Device ID The device ID associated with the neighbor which advertised the information.
IP Addresses The IP addresses associated with the neighbor.
Capability ISDP functional capabilities advertised by the neighbor.
Platform The hardware platform advertised by the neighbor.
Interface The interface (
unit/slot/port) on which the neighbor's advertisement was received.
Port ID The port ID of the interface from which the neighbor sent the advertisement.
Hold Time The hold time advertised by the neighbor.
Advertisement
Version
The version of the advertisement packet received from the neighbor.
Entry Last
Changed Time
Time when the entry was last modified.
Version The software version that the neighbor is running.
Comentarios a estos manuales