HP PROCURVE 3400CL-24G Manual de usuario descargar pdf (Pagina 106)

Enhancements

Release M.10.22 Enhancements

To display information about ports with loop protection, enter this command.

Figure 28. Example of Show Loop Protect Display

[trap <loop-detected>]

Allows you to configure loop protection traps The “loop-detected” trap indicates

that a loop was detected on a port.

[disable-timer <0-604800>]

How long (in seconds) a port is disabled when a loop has been detected. A value

of zero disables the auto re-enable functionality.

Default: Timer is disabled

[transmit-interval <1-10>]

Allows you to configure the time in seconds between the transmission of loop

protection packets.

Default: 5 seconds

Syntax: show loop-protect <port-list>

Displays the loop protection status. If no ports are specified, the information is

displayed only for the ports that have loop protection enabled.

ProCurve(config)# show loop-protect 1-4

Status and Counters - Loop Protection Information

Transmit Interval (sec) : 5

Port Disable Timer (sec) : 5

Loop Detected Trap : Enabled

Loop Loop Loop Time Rx Port

Port Protection Detected Count Since Last Loop Action Status

---- ----------- --------- ---------- ---------------- ------------ --------

1 Yes No 0 send-disable Up

2 Yes No 0 send-disable Up

3 Yes No 0 send-disable Up

4 Yes No 0 send-disable Up

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 196 197

Sin comentarios

HP PROCURVE 3400CL-24G Manual de usuario Pagina 106