HP PROCURVE W.14.03 Manual de usuario descargar pdf (Pagina 345)

100

101

IPv4 Access Control Lists (ACLs)

Configuring Extended ACLs

Configure ACEs in a Named, Extended ACL and/or Enter the “Named

ACL” (nacl) Context. Configuring ACEs is done after using the ip access-

list standard < name-str > command described on page 9-56 to enter the “Named

ACL” (nacl) context of an ACL. For an extended ACL syntax summary, refer

to table 9-7 on page 9-53.

Syntax: < deny | permit > < ip | ip-protocol | ip-protocol-nbr >

(nacl

< any | host < SA > | SA/ mask-length | SA < mask > >

context)

< any | host < DA > | DA/ mask-length | DA < mask > >

[ precedence ] [ tos ] [ log ]

Appends an ACE to the end of the list of ACEs in the current

ACL. In the default configuration, ACEs are automatically

assigned consecutive sequence numbers in increments of 10

and can be renumbered using resequence (page 9-80).

Note: To insert a new ACE between two existing ACEs in an

extended, named ACL, precede deny or permit with an appro-

priate sequence number along with the ACE keywords and

variables you want. (Refer to “Inserting an ACE in an Exist-

ing ACL” on page 9-77.)

For a match to occur, a packet must have the source and

destination addressing criteria specified in the ACE, as well

as:

• the protocol-specific criteria configured in the ACE,

including any included, optional elements (described later

in this section)

• any (optional) precedence and/or ToS settings configured

in the ACE

< deny | permit >

For named ACLs, these keywords are used in the “Named ACL”

(nacl) context to specify whether the ACE denies or permits a

packet matching the criteria in the ACE, as described below.

9-57

1 2 ... 340 341 342 343 344 345 346 347 348 349 350 ... 593 594

Comentarios a estos manuales

Sin comentarios

HP PROCURVE W.14.03 Manual de usuario Pagina 345

Comentarios a estos manuales

Relacionado con productos y manuales para Software HP PROCURVE W.14.03