HP Q.11. (2510-24) Manual de usuario descargar pdf (Pagina 22)

1-6

Getting Started

Conventions

Command Prompts

In the default configuration, your switch displays the following CLI prompt:

ProCurve Switch 2510-24#

To simplify recognition, this guide uses ProCurve to represent command

prompts for all models. For example:

ProCurve#

(You can use the hostname command to change the text in the CLI prompt.)

Screen Simulations

Figures containing simulated screen text and command output look similar

to this:

Figure 1-1. Example of a Figure Showing a Simulated Screen

In some cases, brief command-output sequences appear outside of a

numbered figure. For example:

ProCurve(config)# ip default-gateway 18.28.152.1/24

ProCurve(config)# vlan 1 ip address 18.28.36.152/24

ProCurve(config)# vlan 1 ip igmp

Port Identity Examples

This guide describes software applicable to both chassis-based and stackable

ProCurve switches. Where port identities are needed in an example, this guide

uses the chassis-based port identity system, such as “A1”, “B3 - B5”, “C7”, etc.

However, unless otherwise noted, such examples apply equally to the

stackable switches, which for port identities typically use only numbers, such

as “1”, “3-5”, “15”, etc.

ProCurve(config)# show version

Image stamp: /sw/code/build/dosx(ndx)

Dec 11 2007 11:44:02

U.11.03

1340

Boot Image: Primary

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 293 294

Sin comentarios

HP Q.11. (2510-24) Manual de usuario Pagina 22