HP StorageWorks Enterprise File Services WAN Accelerator Manual de usuario Pagina 116

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 232
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 115
116 CONFIGURING THE HP EFS WAN ACCELERATOR
Setting Alarm
Parameters
You can set alarms in Reports - Alarm Settings page.
Enabling alarms is optional.
To set alarm
parameters
1. Click the Setup tab to display the Setup menu.
2. Click Reports to display the Reports - Alarm Settings page.
Figure 2-47. Reports - Alarm Settings Page
3. Use the controls to complete the configuration, as described in the following table.
Control Description
CPU Alarms Raise Alarm When CPU Utilization Reaches. Specify this option to trigger an alarm if
the average and peak threshold for the Central Processing Unit (CPU) utilization is
exceeded. When an alarm reaches the rising threshold, it is activated; when it reaches the
lowest or reset threshold, it is reset. After an alarm is triggered, it is not triggered again
until it has fallen below the reset threshold.
This alarm is enabled by default, with a rising threshold of 90% and a reset threshold of
70%.
Rising Threshold. Specify rising value CPU utilization.
Reset Threshold. Specify reset value for CPU utilization.
Data Store Alarm Send email if stale data replaced by fresh data is less than __ day(s) old. Specify this
option to trigger an alarm if data in the data store is replaced with new data before the
time period specified.
Vista de pagina 115
1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 231 232

Comentarios a estos manuales

Sin comentarios