Hp 3PAR Solutions Software for vSphere Manual de usuario descargar pdf (Pagina 22)

3.6

Installing 3PAR VAAI Plug-in for VMware vSphere 4.1

3PAR VAAI Plug-in 1.1.0 for VMware vSphere 4.1 Users Guide

3.1.3 Installing the Plug-in Using the VMware vSphere CLI for ESX/ESXi Hosts

To perform the installation using VMware vSphere CLI for ESX/ESXi hosts:

1 Install VMware vSphere CLI on a windows machine. (Please follow the VMware vSphere CLI

installation user guide for instructions).

2 Copy 3PAR_vaaip_InServ-110.zip to a windows local folder (e.g., c:/tmp).

3 From the vSphere CLI command prompt, issue the following command with appropriate

server name:

vihostupdate.pl –i –b c:/tmp/3PAR_vaaip_InServ-110.zip --server

4 Place the ESX/ESXi server into maintenance mode with the following command:

vicfg-hostops.pl --server <servername> -o enter

5 Reboot the ESX/ESXi server with the following command:

vicfg-hostops.pl --server <servername> -o reboot -f

6 Exit maintanence mode for the ESX/ESXi server with the following command:

vicfg-hostops.pl --server <servername> -o exit

NOTE: Entering Maintenance Mode may initiate a shutdown, pause, or migration

of Virtual Machines in some system environments. Refer to the VMware

documentation for the recommended procedure to enter Maintenance Mode for

servers in your particular environment.

NOTE: After the reboot, the 3PAR_vaaip_InServ module loads automatically. It is

then attached to the 3PAR devices and enabled.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 43 44

Sin comentarios

Hp 3PAR Solutions Software for vSphere Manual de usuario Pagina 22