Hp EML E-series Tape Libraries Manual de usuario Pagina 12
- Pagina / 136
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
CAUTION:
Indicates that failure to follow directions could result in damage to equipm ent or data.
IMPORTANT:
Provides clarifying information or specific instructions.
NOTE:
Provides additi
onal information.
Rack stability
Rack stability protects personnel and equipment.
WARNING!
To reduce the risk of personal injury or damage to equipment:
• Ex tend leveling jacks to the floor.
• Ensure that the full weight of the rack rests on the leveling jacks.
• Install stabilizing feet on the rack.
• In multiple-rack installations, fasten racks together se curely.
• Extend only one rack component at a time. Racks can become unstable if more than one component
is extended.
Taking ESD precautions
Components within the library contain static-sensitive parts. To prevent damage to these parts while
performing installation, m aintenance, or replacement procedures, observe the following electrostatic
discharge (ESD) precautions:
• Always use the Ethernet cables that come with your product.
• Keep the rack turned off during all installation, maintenance, and replacement procedures,
unless specifically instructed to do otherwise.
• Use an antistatic wrist strap when touching internal rack components. To use the wrist strap
properly, place the ba nd around your wrist and attach the clip to the rack frame. Keep the strap
on until you are ready to close the rack doors.
• Keep static-sensitive parts in their shipping containers until ready for installation.
• Do not place static-sensitive parts on any metal surface. If you need to put down a static-sensitive
part, place it inside its protective shipping bag or on a grounded antistatic mat.
• Avoid direct contact with static-sensitive parts. Avoid touching connectors a nd discrete
components.
• Closerackdoorswhennotworkingontherack.
• Be careful when installing the rack or handling components in dry climates or environments where
cold weather heating is used. Environm ents such as these with lower relative humidity have
greater potential to produce static electricity.
12
About this guide
- HP StorageWorks 1
- Contents 3
- About this guide 11
- Rack stability 12
- Taking ESD precautions 12
- Fiber-optic safety 13
- HP technical support 14
- Subscrip 14
- HP web sites 14
- Documentation feedback 14
- 1Libraryoverview 17
- Parts of the library 18
- Base module 20
- Expansion modules 22
- Tape drive expansion module 23
- Card cage expansion module 23
- Capacity expansion module 24
- Controller cards 25
- Interface controller 26
- Functional desc 28
- Load ports and magazines 29
- Tape drives 29
- Operator contr 31
- Numbering 31
- Library over view 32
- 2 Using the library 39
- Powering off the library 40
- Center-door int 41
- Doing an inventory 41
- Attaching 41
- Using the library 42
- Using the OCP 44
- Home screen 45
- OCP tabs and status bar 45
- Timeouts 46
- OCP functions 47
- Status scr een 48
- Figure 31 OCP Sta tus screen 49
- Configuration screen 50
- Figure 32 O 51
- CP Co nfiguration screen 51
- Operations screen 52
- Function Description 53
- Support screen 54
- Controls and indicators 55
- HP Storage 56
- Works Interface Manager card 56
- Power distribution unit 64
- 3 Maintaining the lib rary 67
- Diagnostic support tools 68
- Troubleshooting 68
- Startup problems 69
- Corrective action 70
- OCP p roblems 71
- Robotics proble 72
- Operating probl 73
- Tape drive problems 73
- Possibl e cause Solution 75
- Possible cause Solution 76
- Interface controller problems 77
- Maintaining the librar y 78
- Attribute 79
- Maintaining the library 80
- 4Removingandreplacingparts 81
- Removing and replacing parts 82
- Interface Manager card 83
- CompactFlash memory card 85
- Required tools 87
- Replacin 88
- Power supply in 91
- LTO2 or LTO3 tape drive 92
- LTO4 tape drive 94
- Removing an LTO4 tape drive 95
- Replacing an LTO4 tape drive 95
- Load port 97
- 5 Moving the library 99
- Repacking the library 100
- Moving the library 102
- Characteristic 103
- Specification 103
- Library environ 105
- Acoustics 105
- Regulatory co 107
- Battery statements 107
- Avis relatif aux piles 108
- Istruzioni per la batteria 109
- Japanese batter 110
- Spanish bat ter y notice 110
- Class A equipment 111
- Class B equipment 111
- Canadian notice 112
- (Avis Canadien) 112
- Eu ropean Union notice 112
- Japanese notices 112
- Korean notices 113
- Taiwanese notices 113
- Laser compliance 114
- French laser not 115
- German laser notice 115
- Recycling notices 116
- Czecholslovakian notice 117
- Danish notice 117
- Dutch notice 117
- Estonian notice 118
- Finnish notice 118
- French no 118
- German notice 118
- Greek notice 119
- Hungarian notice 119
- Italian notice 119
- Latvian notice 120
- Lithuanian notice 120
- Polish n 120
- Portuguese noti 121
- Slovakian notice 121
- Slovenian notice 121
- Spanish notice 121
- Swedish notice 122
- Part numbers for 124
- D I nstalling a redundant PDU 125
- Placement of r 126
- Installing a redundant PDU 128
- Glossary 129
Relacionado con productos y manuales para Almacenamiento Hp EML E-series Tape Libraries
Almacenamiento Hp XP P9500 Storage Manual de usuario
(116 paginas)
(116 paginas)
Almacenamiento Hp EVA P6000 Storage Manual de usuario
(316 paginas)
(316 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.096 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales