Hp StorageWorks 2.64 Core Switch Manual de usuario descargar pdf (Pagina 48)

Using QuickLoop Zones

48 Zoning Version 3.1.x/4.1.x User Guide

Configuring QuickLoop Zones

To configure QuickLoop zoning, perform these steps as described in the following

sections.

1. Create a QuickLoop (Only required when zoning by AL_PA.)

2. Define a QuickLoop zone

3. Define a QuickLoop zone configuration

Create a QuickLoop

Refer to the HP StorageWorks QuickLoop Fabric Assist Version 3.1.x User Guide

for information about creating a QuickLoop.

Define a QuickLoop Zone

A QuickLoop zone is a group of L_ports or AL_PAs that can communicate with

each other. These ports and AL_PAs must reside within the same QuickLoop. To

be a QuickLoop zone, every member must be either a looplet (L_port) or an

AL_PA within a single QuickLoop. QuickLoop zones can overlap looplets, but

they must be confined to a single QuickLoop.

QuickLoop zones are hardware enforced, but zones within a single looplet are not

enforceable; therefore, it is recommended that you do not partition devices within

a looplet into different zones.

To define a QuickLoop zone, first enable and create the necessary QuickLoops.

Then specify the list of members to be included and assign a unique zone name. A

QuickLoop zone name must be a unique alpha-numeric string beginning with an

alpha character. The underscore character ( _ ) is allowed and zone names are case

sensitive. For example, Zone1 is not the same name as zone1.

To create a QuickLoop zone, specify QuickLoop zone members by looplet, by

AL_PA, or by combination of the two.

To Specify by Looplet

Specify the QuickLoop zone name, in quotes, and the physical ports to be

included, in quotes. For example:

Zonecreate “QLZoneName”, “0,0; 0,1; 2,6; 2,7; 2,8”

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 103 104

Sin comentarios

Hp StorageWorks 2.64 Core Switch Manual de usuario Pagina 48