Hp StorageWorks Auto Path VA Software Manual de usuario descargar pdf (Pagina 59)

COMMAND-LINE INTERFACE

The Auto Path command-line interface (CLI) can be used only on hosts

connected to multipath-capable devices with the Auto Path driver installed.

The commands supported by this interface and the syntax are described

here:

• autopath adapters (page 60)

• autopath devices (page 61)

• autopath help (page 62)

• autopath paths device (page 63)

• autopath set device (page 64)

You can execute Auto Path commands only from the directory where the

installed Auto Path program files reside.

To exit the DOS window, use the exit command.

If you chose the default directory when you performed the installation,

change the directory to C:\hpss\AutoPath, and then execute Auto Path

commands. If you chose a different directory during installation, change the

directory to the one you specified, and then execute Auto Path commands.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 69 70

Sin comentarios

Hp StorageWorks Auto Path VA Software Manual de usuario Pagina 59