HP RP7 Manual de usuario descargar pdf (Pagina 22)

5. Remove the decorative panel on the rear of the unit by gently prying the panel away from the

base at the tab locations on the top and sides of the panel as indicated below (1). Then pull the

top of the panel away from the base (2) and push straight down on the panel to release the

bottom tabs (3).

6. Route the cables underneath the rear of the base, then through the hole in the center of the

base, then up through the cable retainer on the neck of the stand and into the appropriate I/O

port.

CAUTION: Be sure that the power cord is secured by the retainer clip next to the DC In power

connector on the rear I/O so that the cord does not get pulled out of the connector.

16 Chapter 2 Hardware Upgrades ENWW

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 72 73

Sin comentarios

HP RP7 Manual de usuario Pagina 22