HP EliteBook Folio 1040 G1 Base Model Notebook PC Manual de usuario Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 27
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
,
7
EMBEDDED SECURITY
Feature Function Default setting,
if applicable
Reboot
required
BIOS Integrity Checking (Note: HP Sure Start is only supported on 2013 EliteBook and ZBook notebooks) N/A
Verify Boot Block on every boot
Verify the integrity of the system’s boot block on boot. Disabled Yes
BIOS Data Recovery Policy
Recover System Data (For manual recovery during boot up press (Up
Arrow + Down Arrow + ESC) to restore System Data
Automatic Yes
Restore Network Configuration
to factory defaults
Restore the network address and other network parameters to factory
default
Yes
TPM Embedded Security Manages TPM Module settings N/A
TPM Device
Exposes the integrated TPM module Available Yes
Embedded Security Device
State
Enables the integrated TPM module Disabled Yes
TPM Reset to Factory Default
Sets TPM Embedded Security settings to factory default No Yes
OS Management of TPM
Allows operating system to manage TPM module Enabled Yes
Reset of TPM from OS
Allows reset of TPM module from within the operating system Disabled Yes
System Management Command Allows authorized personnel to reset security settings in case of a
service event NOTE: In the event BIOS password is lost and this option
is disabled authorized personnel will not be able to remove lost
password.
Enabled Yes
UTILITIES
Anti-Theft Tools N/A
Intel Anti-Theft
Server-based security N/A
Active Activates this option Enabled Yes
Suspend Allows the feature to be disabled temporarily Disabled Yes
Absolute Software Computrace
N/A
Current State Read-only setting that reports the current status
[Inactive/Active/Permanent Disabled]
Inactive N/A
Hard Drive Tools N/A
Save/restore Master Boot
Record (MBR) of the system
hard drive
Saves a baseline MBR that can be restored if a change is detected
NOTE: Not applicable for UEFI boot modes
Disabled Yes
DriveLock
Allows configuration of DriveLock Master and User passwords Disabled N/A
Automatic DriveLock
Requires the BIOS to authenticate the user before the drive is unlocked.
The user can be a BIOS user (managed by F10 Setup) or a ProtectTools
user (managed by the OS).
Following authentication, the BIOS automatically supplies the
DriveLock password.
A BIOS administrator password is required for this feature and is set as
the DriveLock master password.
Disabled N/A
Disk Sanitizer
Erases all data on selected hard drive; typically used prior to
repurposing or donation (Not supported under RAID mode or on SSDs)
N/A
Secure Erase
Uses a built-in command drive to erase data on an SSD N/A
System IDs N/A
Asset Tracking Number
Allows custom configuration of an asset tag (up to 18 characters) Serial Number No
Ownership Tag
Allows custom configuration of an ownership tag (up to 40 characters) Blank No
Ownership Tag 2
Allows custom configuration of an ownership tag (up to 40 characters) Blank No
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

Comentarios a estos manuales

Sin comentarios